Mopar Tools C-4698A Seal Installer

The Mopar Tools C-4698A is a specialty seal installer designed for use in automotive applications, particularly with Chrysler, Dodge, Jeep, and RAM vehicles. This tool is used to correctly and efficiently install seals, like crankshaft or camshaft seals, ensuring a proper fit and preventing leaks.

Here are some general instructions on how to use a seal installer like the C-4698A:

1. Preparation:

- Ensure the work area is clean and free from debris.

- Gather all necessary tools and parts, including the new seal.

- Wear appropriate safety gear, such as gloves and safety glasses.

2. Remove the Old Seal:

- Carefully remove the old seal using the appropriate removal tools.

- Clean the sealing surface thoroughly to remove any residue or contaminants.

3. Position the New Seal:

- Lightly lubricate the new seal with the appropriate lubricant (usually specified by the seal manufacturer).

- Place the new seal onto the sealing surface, ensuring it is properly aligned.

4. Using the Seal Installer:

- Fit the Mopar C-4698A seal installer over the new seal.

- Gradually apply pressure, either by striking the installer with a hammer or using a press if specified, to push the seal evenly into place. Ensure even pressure distribution to avoid damaging the seal.

- Continue until the seal is fully seated as per the specifications.

5. Verify Installation:

- Check that the seal is flush and evenly seated.

- Inspect for any signs of misalignment or damage.

6. Reassemble:

- Reassemble any components that were removed during the process.

- Double-check that everything is correctly reinstalled.

7. Test:

- Start the engine and check for any leaks around the newly installed seal.

For specific vehicle applications and detailed steps, always refer to the vehicle’s service manual and follow the manufacturer’s recommendations.